Kuro Concepts CW Vape Coil Winders

Kuro Concepts CW Coil Winders

To make your own coils just trap your wire, then rotate the top cap and you will get that perfect micro coil in just seconds every time.
Select Coil Winder:
Blue CW-20 – Make 2 mm coils
Red CW-25 – Makes 2.6mm coils

Instructions:

Insert the socket screw into the appropriate hole of the winder section:
For 26 – 28 gauge wire, use screw hole number 1 For 20 – 24 gauge wire, use screw hole number 2
Insert wire through hole on the side of the handle. Leave about 1/2″ of the wire protruding from the hole. Hold the end of the wire against the handle so it won’t pull through. Pull the loose end of the wire around the shaft. Slide the winder section over the shaft with the pin facing toward the handle.
Turn the winder section so that it catches the wire and starts wrapping it around the shaft. Keep light pressure against handle while winding. Excessive pressure will force smaller gauge wire to wrap over itself.
When finished, remove winder and straighten the wire end that protrudes from the hole in the handle. Push up on the wire to slide coil up. Carefully grab the coil at the bottom to slide it off the shaft.